Skydemon on ipad 2 with powerflarm core. Latest software version on Ipad and Skydemon. The Ipad connects to the butterfly connect network with correct key.This can be seen in ipad setup wifi. Sometimes Skydemon works first time via powerflarm go flying and then drops out with error mesage "lost GPS signal" then "Failed to establish a connection with the Butterfly connect unit"
Nothing I then do will re-establish contact even rebooting ipad and Flarm core. Next time I try it works or not. Skydemon works fine with normal Go Flying. Tried new ipad but no different.Any ideas?

It's not a bug we have managed to reproduce in house. Can you give us some simple steps that make it happen?

Hi Tim
iPad 2
Software up to date
Just updated to latest Skydemon
I log out and log back in to Skydemon and I set my route while connected to Wifi
I turn the IPad off and go to hanger.
I start engine and turn on Flarm and IPad
On the iPad I check it is connected to Flarm/Butterfly Wifi network.
Then I go flying via Setup connection options Flarm, go flying.
I do not get an error message for the first or possibly second flight but after the third flight I get the error message every ten minuets.
The error message gives date and time and says " There was a communications error during operation "Downloading TAFs (or notams etc.) Timed out "...............etc

This happens every time I go flying. I have photos of error message if they will help.

Derek

Hi Tim
iPad 2
Software up to date
Just updated to latest Skydemon
I log out and log back in to Skydemon and I set my route while connected to Wifi
I turn the IPad off and go to hanger.
I start engine and turn on Flarm and IPad
On the iPad I check it is connected to Flarm/Butterfly Wifi network.
Then I go flying via Setup connection options Flarm, go flying.
I do not get an error message for the first or possibly second flight but after the third flight I get the error message every ten minuets.
The error message gives date and time and says " There was a communications error during operation "Downloading TAFs (or notams etc.) Timed out "...............etc

This happens every time I go flying. I have photos of error message if they will help.

Derek

Hi Tim
iPad 2
Software up to date
Just updated to latest Skydemon
I log out and log back in to Skydemon and I set my route while connected to Wifi
I turn the IPad off and go to hanger.
I start engine and turn on Flarm and IPad
On the iPad I check it is connected to Flarm/Butterfly Wifi network.
Then I go flying via Setup connection options Flarm, go flying.
I do not get an error message for the first or possibly second flight but after the third flight I get the error message every ten minuets.
The error message gives date and time and says " There was a communications error during operation "Downloading TAFs (or notams etc.) Timed out "...............etc

This happens every time I go flying. I have photos of error message if they will help.

Derek