Hi

i installed the new beta this morning and plan to the it up in the air later on today.



Whilst copying the charts I got an error twice "Operation failed. Unable to read beyong the stream".

As it did copy files I started to sync the device and it started to copy new file versions over and right

after Notams it failed again with the same error. This is whilst installed it using an sd card reader



I then plugged in the SD card in the GPS and connected it via activsync --Synced device again and

no problem. After the notams it updated the charts (where ir previously failed)




________________________________________________________________________
Galaxy Tab Plus 7 inch, NavsGo GO7100 as of March11

That was very good. Congratulations. I understand height or elevation will need to be calibrated for each particular set, while the speed should be correct as is, am I right? Any idea about the easiest way to retain the set calibration so that it would not have to be repeated for every subsequent flight? Thanks

Very Newbytheway

DurhamTeaseAirport