I searched the forum before posting, but what I found was not exactly what I'm looking for. The scenario is flight planning from A to B with a touch and go in C, which is in the middle between A and B. Of course I can add C to my route, but how to say to SD that I want to land in C and then proceed to B? I mean, descending, then landing, then climbing again in one single route.

Thanks everybody.

Lozzi

Thanks for the reply, chrisn.

As you wrote, actual landing (even for touch and go) is different than flying a very low and short leg over the runway . No 'make approach', incorrect evaluation of times and consumptions, etc. It seems there's no specific function or procedure to handle touch and go within a route...

Lozzi