I am having a couple of issues with the software at the moment.

1 I cannot drag the route line once I have set start and destination points ( although this was possible when using evaluation prog. since I have purchased the license this feature has gone?)

2 I have tried to manually input waypoints with absolutely no success using the waypoint insertion tab.This is most annoying as I have had to sit and tap the screen a fraction at a time to try and get position exact (didnt happen but as close as I was able without spitting the dummy and hurling pc at the nearest wall LOL)

I can still drag route on the desktop pc but same problem with adding waypoints.

Any help most welcome.

I will contact skydemon after the easter break to try and resolve this

Cheers

William

always willing to learn even if it is slowly LOL

One other way is to start by entering the main waypoins  .. say two airfields, start & end. Then tap and hold on a point to which you want to "drag" the line. You will then be given the option to "insert" that point between the first 2.

I have use this method quite easily to go around airspace etc while en route. Think it wd also be feasible in a flexwing.

D