Hello

Over the alps, the airspace C start at FL130. Actually it is very dificult to find out, where the seperation line are.
I think it will be much better to make it like in the ICAO-chart:




Chris

I've left this post where it is rather than moving it to Suggestions, but I will point out that the non-drawing of blanket controlled airspace is by design in SkyDemon. Drawing a "dividing line" on its own is beyond the current scope of our mapping engine. Presumably the line is highlighted if you use the What's Here menu to inspect the airspace either side?

No, there is no information about the charlie airspace.
If I set the dynamic airspace removal to "hide airspace when planning" above 12000ft, the boundary is also not visible, thats strange for me. Only in the virtual radar you can see it.



Chris