Last week I flew to a south coast airfield and used one of my previously saved routes. All good.

On the way home I decided to take the scenic route home, so was not following my planned route home.

At a certain point I clicked on "Direct To" to return to my home airfield.

This route took me very close to the edge of the ATZ for Chichester/Goodwood.

I thought it would be a good idea to give them a call on the radio, so clicked on the "Radio" tab.

Their frequency wasn't listed but I did eventually find it by clicking on the map.

Would it be possible for the "Radio" tab to list en-route frequencies dynamically?

For example, list frequencies within, say, 5 NM either side of my current position of the "Go Direct To" track?

Thanks

Tony

Hello, 

I think that the difficulty Skydemon has is that in the french AIP there are no frequencies attached to most of the R and D zones. Ths AIP only shows where you can get informations about the zone.
See the pictures below for the R115 you are referring to, it says you can get information from AQUITAINE INFO, PYRENNEES INFO or MARSAN APP without specifying the frequency to be used !